HY3030EP 0-30V 0-30A| Programmable DC Power Supply| Arduino Nano Control

Volteq HY3030EP is basically the same as HY3030EX, except that it comes with built-in control and programming with Arduino Nano. If you are familiar with Arduino, writing software code to control this power supply and run automatic testing is a piece of cake. We supply a sample code to let you set and read voltage and current output via USB, you can also use our softare to calibrate the power supply, generate a multi-step linear ramp, and run a fixed amp-minute operation, etc. This power supply is ideally suited for automatic testing, battery charging/maintenance, DC/servo motors, anodizing and plating applications. Currently the following I/O are used, leaving the rest for other application/controls you may have: 

Features & Specifications:

• Control: front panel or via Arduino Nano using USB
• Two level of control for both current and voltage outputs: coarse and fine for ease of use
• Outputs: 0-30 V and 0-30 A
• Protection: over-voltage and reverse-voltage protection
• Input voltage: 110V AC and 220V AC switchable
• Voltage Stabilization: <=0.2%
• Current Stabilization: <=0.5%
• Load Regulation: <=0.3%
• Ripple noise: CV <= 1%
• LCD reading accuracy: +/-1% +/-1 digit
• Environment: 0-40C, relative humidity < 90%
• Warranty: 1 year